Replica plumbing pipe gas light

USD $436.71

Quantity discounts available:
USD $436.71USD $414.87

Pendant drop length * 

Specify a precise overall length as a custom fit in mm. Minimum 500mm to allow for tap mechanism.

Custom Finish * 

Choose here an alternate surface finish to default galvanised

Pendant tap

Choose to include a tap or lever type for 12 Volt dimming control or as decorative feature for mains voltage

Lamp shade option * 

Choose Country Voltage and hardware option

Choose here to make 240V or 120 Volt FOR USA AND CANADA REQUIREMENTS. This does not provide a UL Listed product but provides UL compatible hardware.

Warranty: 1 Year

Download PDF

Product Description

Replica plumbing pipe gas light. This light fitting can be used to light up a kitchen table or bar or just as a ceiling light feature. Solid Brass E14 lamp holders are attached above special 3 inch Hurricane shade galleries and Hurricane lamp shades.  Secures to the ceiling via steel pipe and flange plate which is also the wiring point.

This design is made to replicate a gas light style used for a number of years as interior light of service rooms and would have been run on coal gas supply in the early 1900’s. This light is however wired to provide a light source as modern LED or vintage filament in 12 Volt or mains voltage.

Dimming and voltage

Seen photographed with a dimming lever together with control chains this configuration requires us to supply with a 1-10V dimmable 12 Volt driver and 12 Volt candelabra globes. Dimming control can also be via red inline tap style for low voltage solution.

If mains voltage is required then dimming is only possible as wired in main switch and dimmer (not supplied). In this case 240 Volt or 120 Volt type E14 globes should be used. We can still supply with a tap or lever mechanism but these will not supply dimming. If ordered with no tap or lever these will be replaced with a plugged cap in a tee fitting.

Can be ordered in Galvanised, Rusted, or Raw steel painted Flat Black. The rusted finish may continue to age slightly but a coating of “Penatrol” can seal in a darker rustic finish.

Bulb not included, choose from our range of E14 globes
Recommended bulbs are listed below

Vintage replica gas light industrial design.
Steel and cast plumbing pipe construction.
Mounting flange compatible with 4 inch junction boxes.
Solid brass lamp holders.
Glass shades
Overall height specifiable to order.
Range of surface finishes.

Finish options:
Plumbing pipe components available in Raw black steel, Galvanised, Rusted, Brass painted, and Flat black finish.

Indoor use only.
E14 12 Volt with driver, 240VAC (eg. AUS, UK, NZ) or E12 120VAC (eg. US, CA).
Integral earth wire.
Secures to the ceiling via cast flanges.
Wiring connections are made through the flanges.
Globes 60W Max.
Globes not included.


Height: Configurable overall. (Minimum 500mm)
Width: 830mm.

Recommended globes for this product…